Large-area tunnel spacer made of fibre concrete for fixing the tunnel sealing film. On request with glued-on geotextile to protect the tunnel film and available in the dimensions 80 x 80 mm or 80 x 100 mm.
One-component adhesive for sealing clamping points made of fibre-reinforced concrete. Supplied in a set of 3 tubular bags of 500 g each. Advantages: - Easy dipping of the plugs due to very large opening of the tubular bags - Can also be used on slightly damp surfaces - Shelf life in original container approx. 12 months (cool and dry) - Temperature resistant from approx. -40 °C to +80 °C - Consumption quantity for 1,000 pcs plugs approx. 3 kg Test certificates available: - Watertightness test - Fire behaviour F180 - Airborne sound insulation - Drinking water suitability
Filling or cartridge press in light, strong design for bags and cartridges, with smooth push rod. Stepless feed for optimum power transmission, hand-friendly handle.
Cone made of cast concrete for closing clamping points. After removing the cone K22/5 or K26/5, the cast concrete cone is glued into the conical opening. Only limited suitable for fair-faced concrete. Test certificates available: - Watertightness test
Prefabricated cone in high-quality exposed concrete for closing tie holes with an inner diameter of 22 to 26 mm in combination with cones with a fitting length of 10 mm as well as OKTAGON-PLUS 22 or 26. The Sichtbetonkegel Universal is only used to visually close the tie hole and does not provide protection against water under pressure.
Cone in high-quality fair-faced concrete for closing clamping points. After removing the cone K22/5 or K26/5, the exposed concrete cone is glued into the conical opening. The cone is slightly shorter than the conical opening, which results in the formation of a shadow gap.
Spacer with 3-point support made of cast concrete. With shuttlecock clip for easy attachment to the reinforcement. The shuttlecock clip ensures a secure hold at the crossing point of the reinforcement. Due to the low contact points with the formwork, very suitable for exposed concrete.
Extra strong single spacer made of fibre-reinforced concrete with groove and two cross hooks for a secure hold at the crossing point of the reinforcement.
Fibre-reinforced concrete tube, cut on both sides, for the production of formwork clamping points on the construction site. By cutting the tube to length, the required lengths can be produced on site. Suitable for tie rods with DYWIDAG thread 15 mm. Test certificates available: - Watertightness test - Fire behaviour F180 - Airborne sound insulation - Drinking water suitability
Pre-cut fibre-reinforced concrete tube for the production of formwork clamping points on the construction site. Suitable for tie rods with DYWIDAG thread 15 mm. Test certificates available: - Watertightness test - Fire behaviour F180 - Airborne sound insulation - Drinking water suitability
Square spacer with flat support made of cast concrete. With eyelet wire for attachment to reinforcement. Not suitable for exposed concrete because of the flat support.
Square spacer with flat support made of cast concrete. With plastic clip for easy attachment to reinforcement. Not suitable for exposed concrete because of the flat support.
