Prefabricated cone in high-quality exposed concrete for closing tie holes with an inner diameter of 22 to 26 mm in combination with cones with a fitting length of 10 mm as well as OKTAGON-PLUS 22 or 26. The Sichtbetonkegel Universal is only used to visually close the tie hole and does not provide protection against water under pressure.
Cone in high-quality fair-faced concrete for closing clamping points. After removing the cone K22/5 or K26/5, the exposed concrete cone is glued into the conical opening. The cone is slightly shorter than the conical opening, which results in the formation of a shadow gap.
Cone made of cast concrete for closing clamping points. After removing the cone K22/5 or K26/5, the cast concrete cone is glued into the conical opening. Only limited suitable for fair-faced concrete. Test certificates available: - Watertightness test
One-component adhesive for sealing clamping points made of fibre-reinforced concrete. Supplied in a set of 3 tubular bags of 500 g each. Advantages: - Easy dipping of the plugs due to very large opening of the tubular bags - Can also be used on slightly damp surfaces - Shelf life in original container approx. 12 months (cool and dry) - Temperature resistant from approx. -40 °C to +80 °C - Consumption quantity for 1,000 pcs plugs approx. 3 kg Test certificates available: - Watertightness test - Fire behaviour F180 - Airborne sound insulation - Drinking water suitability
Filling or cartridge press in light, strong design for bags and cartridges, with smooth push rod. Stepless feed for optimum power transmission, hand-friendly handle.
Linear, labour-saving plastic spacers for lower reinforcement. The cut-outs ensure proper flow of the concrete without compromising stability and at the same time reduce the visibility of the spacer on the finished concrete surface.
Linear, labour-saving plastic spacers for lower reinforcement for all applications where the reinforcement has to be set against soft surfaces, e.g. insulation boards. For this purpose, the Drunterleiste is placed with the flat side on the insulation. With holes on the sides for better concrete flow without affecting stability.
Linear, labour-saving plastic spacers for lower reinforcement for all applications where the reinforcement has to be set against soft surfaces, e.g. insulation boards. For this purpose, the Drunterleiste is placed with the flat side on the insulation.
Linear, labour-saving plastic spacers for lower reinforcement with grid notches. The grid notches prevent the first reinforcement layer from slipping. The cut-outs ensure proper flow of the concrete without compromising stability and at the same time reduce the visibility of the spacer on the finished concrete surface.
